Hebei Jinge Hoisting Machinery
Manufacturing Co. Ltd.
Hebei Jinge Hoisting Machinery
Manufacturing Co. Ltd.
by Jinge on 2023-03-08
Many users just glanced at the instruction manual of steel plate tongs, and only know that when using a single steel plate tongs, they should be clamped in the middle of the steel plate, but they don’t know the importance of doing so, so there may be The clamping position of a single steel plate tongs is wrong. So, what problems will be caused by the wrong clamping position of a single steel plate clamp?
1. If a singlesteel plate tongs is not accurately clamped at the center of the steel plate, the steel plate may tilt to one side during use due to the offset of the center of gravity, or may fall.
2. If a single steel plate lifting clamp clamps the steel plate from the side of the steel plate, the jaws cannot be clamped into the steel plate structure, and the steel plate cannot be lifted due to insufficient friction of the jaws.
3. If a singlesteel plate tongs clamps the steel plate from one end of the steel plate, the steel plate tongs cannot be stuck on the steel plate structure, and the steel plate may fall off due to insufficient clamping force of the jaws.
To sum up, it can be seen that the user needs to accurately clamp a single steel plate tongs at the middle section of the top of the steel plate. If the lifting steel plate is too large, it cannot be lifted with a single steel plate clamp, so two or more steel plate clamps are usually used to clamp the steel plate. If you use a single steel plate tongs, you need to pay attention to the above points to avoid the above problems, so as to ensure the safety of users themselves.
